![]() ![]() If the cutter has a flat end, this diameter corresponds to the diameter of the tip. Tool diameter in drawing units Maximum diameter of the top of the V of the cutter. Note : For this operation, the tool must be a V-Cutter. If the angle and larger than this value, no ascent of the tool will be generated. Maximum angle for the corners where a ascent of the tool will be added. If this parameter is set to Autothe maximum depth is automatically calculated so that the cutter does not go down lower than allowed by the V. This value is a positive value representing the maximum depth to be reached. This value is used to do calculations if Max Depth is set to Auto. This value will allow the plugin to calculate a maximum machining depth so as not to go lower than allowed by the V of the cutter. Maximum diameter of the top of the V of the cutter. In case it is not possible to take all the depth of a sudden, you can limit the maximum depth with the Max Depth property, and use several separate operations.Īfter selecting a closed shape, use the Machining menu to create a V-Engrave operation. This plugin does not support multiple passes for the moment, so you should be careful. ![]() The V-Engrave operation will therefore vary the machining depth to achieve this purpose. The principle of this machining operation is to cut between two lines forming a "limit" while maintaining the edges of the V cutter in contact with these limits. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |